The Montana Western #31 $10,000 matching fund challenge was met mid-December of 2025, and the DULUTH DSS&A Sleeping Car met its respective $10,000 matching fund challenge early this year.
We’re excited to announce that $20,000 total will go toward the Montana Western #31’s (AKA Great Northern #2313) radiator restoration. While the DULUTH’s $20,000 with go toward the construction of new mahogany veneer walls (with marquetry) for the sleeping car’s smoking room!
We can’t thank everyone enough for their support with these respective projects. Please look forward to more updates regarding both restorations later this year!
To help Mid-Continent restore the DULUTH to its former glory, please consider making a donation to the DSS&A Sleeper DULUTH Fund. Donating is tax-deductible and easy to do. You can make your donation via mail or donate online using the donate button below.
If you choose to donate by mail, please be sure to write in “DSS&A Sleeper DULUTH Fund” on the printable donation form or check memo line. Credit/debit card donations can also be accepted via phone at 608-522-4261 or 800-930-1385 by speaking to our staff during administrative office hours Monday-Friday.
We are thrilled to announce two separate $10,000 matching fund challenges to support the preservation and restoration of two historically significant rail cars in our collection. Thanks to two generous donors, every dollar you give will be matched dollar-for-dollar, up to $10,000 for these two projects!
🔹 Montana Western #31 (AKA Great Northern #2313): The funds will be used to rebuild the radiator in this oldest surviving EMC gas-electric motorcar. The Montana Western #31 was the 30th unit of its kind and represented the cutting edge of technology at a time when railroads were seeking alternatives to steam service on branch lines.
🔹 Duluth South Shore and Atlantic DULUTH Sleeper Car: This is an extremely rare example of a wooden sleeper car. The matching fund drive is targeted to provide the needed funds to replicate the original Men’s Smoking Room in the DULUTH. The Men’s Smoking Room had two sinks, a saloon (toilet) and a long sofa. This room was the area of the car where men could gather and have a smoke or wash up during their overnight trip along the Duluth South Shore & Atlantic route between Sault Ste. Marie and Duluth, MN. Drawings have already been made and with the $10,000 challenge donation and matching funds, we will be able to construct new mahogany veneer walls (with marquetry) for the smoking room.
The Men’s Smoking Room floorplan in the DULUTH.
The interior of the Men’s Smoking Room as it stands currently.
Help us keep these pieces of history alive! Donate to one or both projects today using the buttons below.
The 5-day long “All Hands on Deck” session held on June 18th-22nd by the MCRM Restoration Department was a great success. The very successful and productive “All Hands on Deck” Session had a total of 32 volunteers participating in the event, with an average of 20 volunteers per day. In total the volunteers put in over 800 hours of work during this session. The volunteers really did an outstanding job and performed an immense amount of work in a matter of a few days.
Anyone visiting the MCRM Car Shop after this event will notice a significant difference in the appearance of the cars that were worked on. The progress made during this session exceeded the expectations. The progress made was achieved due to the support, commitment and hard work of the volunteers. Progress made during the 5-day All Hands on Deck Session is summarized below. Note that several of the photos capture the status of the projects before and after the All Hands on Deck session. East Jordan & Southern Combine #2: The volunteer crew of Pete, Jeff Hu., Jeff A., Jeff Ha and Dean S. assembled and installed the Buntin seat frames, seat back and seat bottoms for the seats in the passenger section. This included boring the holes in the truss plank for the foot rests and installing the arm rests on the aisle castings. The crew also installed the second overhead oil lamp in the passenger section as well as the oil bracket lamp adjacent to the saloon. With work wrapping up in the passenger section additional work was performed in the baggage compartment.
BEFORE: The EJ&S #2 as Dean S., Jeff Hu and Jeff A. work on installing brackets on the ends of the seat backs.
Pete, Jeff A. and Jeff Hu installing the seat brackets on the east side of the car.
The new seats and cushions installed on the east side of the car.
AFTER: The EJ&S after three days of work to install the new seats. The newly installed seats on the left are covered with sheets.
Duluth South Shore & Atlantic Sleeping car DULUTH: The volunteer crew of Karl, Bob B., Ron, John, Dean V., Nate, Andrew, Tom, Jack, Jerry F. and Bill worked on the DULUTH during the AHOD session. During the session we took delivery of six new berth tables, six folding window screen frames, the sleeping compartment window panels and trim pieces for the smoking room. Work performed included installing trim pieces, headliner battens and a window bottom rail in the smoking room. In the sleeping compartment the new window post panels were trimmed, fit and installed along with the berth partition overlay pieces. The accomplishments in the sleeping compartment are significant as they will allow us to move on to installing the heating pipes and lower berths.
On the exterior of the car over 15 feet of the car received new car siding on the area below the windowsill. Another significant accomplishment was the installation of the new 8-piece windowsill for the east side. Each piece of the windowsill was doweled and screwed together to make for a one-piece sill 65 feet in length. Once assembled the windowsill was lifted into place with the help of ten volunteers evenly spread out across the length of the sill. Once in place the windowsill was screwed in place and the screw holes were plugged.
BEFORE: The sleeping compartment prior to the AHOD.
Part of the crew in the DULUTH. Dean V., Ron, Steve, Bob and Karl.
Ron in the process of install one of the berth partitions.
AFTER: The sleeping compartment after the AHOD.
Karl and John installing new lower siding on the DULUTH.
Volunteers in the process of installing the one-piece windowsill into place on the DULUTH.
Soo Line Caboose #99085: The volunteer crew of Richard P., Larry S., Bob R., David P., Dean S., Dean V., Jeff Hu., Altha, Jack, Jerry F., Gregg, Jane and Bill worked on the caboose during the AHOD session. Work performed included installing the new car siding on the east side of the car and framing out all four of the windows on the car. On the west side of the car new siding was installed around SW window and the bottom six inches of a number of boards were cut off and replaced. Epoxy repairs were made as needed on the car sides and the end beams. The entire car body was sanded, and all bare wood was primed. With the exception of a few areas awaiting further repairs, the entire car received two coats of the caboose red.
The new window frames for the car body and cupola were primed and given two coats of finish color. New wood roof drip edge pieces were made and are waiting to be installed along with the new rubber roof.
BEFORE: Jack and Jerry installing the new car siding on the east side of the caboose.
Work in process on the west side of the caboose.
AFTER: The caboose after five days of work.
Chicago & Illinois Midland Business Car #90: The volunteer crew of Steve, Dean V. and Jerry M. worked on the C&IM #90 business car. Work continued to route and install new wiring for the light fixtures in the south end of the car. The light in the toilet room has been energized and shortly power to the south entranceway and rear vestibule will be completed. In the south stateroom good progress was made with replicating the wardrobe. Final fitting of the door to the door frame was performed and the material for the wardrobe side and bottom were cut to size. All pieces of the wardrobe were sanded and the interior surfaces were sealed and stained.
Steve working on the wiring inside the C&IM #90.
Jerry M. and Dean V. staining the side panel for the wardrobe in the C&IM #90.
Rock Island Combine #1094: Fred B. And David M. braved the sun and heat to work on needle scaling the east side of the car. The process has them getting down to bare metal and removing all of the rust. Good progress was made as over 60% of the east side of the car has been needle scaled, wire brushed and primed.
Fred and Dave M. working on the CR&IP #1094.
Lake Superior & Ishpeming coach #64: Bob and Larry worked inside the #64 coach. Two new end doors were received as well as a new panel for the smoking room wall. The wood panel for the smoking room was installed while the end doors wait to be fitted to the car. Inside the car stripping and sanding the car continued on the south end of the car.
The new middle panel in LS&I #64 smoking room.
The new oak end doors for the LS&I #64.
“I’d like to thank all of the amazing volunteers who put in a tremendous amount of work during the past 5 days! Your collective efforts were amazing and a real morale booster to the restoration efforts at Mid-Continent. I’d also like to extend a special thanks to the volunteers that prepared all of the meals for the entire crew during the session.” – Bill, Restoration Dept. Manager
Some of the AHOD volunteers that were on hand during the session.
Steve serving up lunch time for the AHOD volunteers.
To help Mid-Continent restore the DULUTH to its former glory, please consider making a donation to the DSS&A Sleeper DULUTH Fund. Donating is tax-deductible and easy to do. You can make your donation via mail or donate online using the donate button below.
If you choose to donate by mail, please be sure to write in “DSS&A Sleeper DULUTH Fund” on the printable donation form or check memo line. Credit/debit card donations can also be accepted via phone at 608-522-4261 or 800-930-1385 by speaking to our staff during administrative office hours Monday-Friday.
Contains information related to marketing campaigns of the user. These are shared with Google AdWords / Google Ads when the Google Ads and Google Analytics accounts are linked together.
90 days
__utma
ID used to identify users and sessions
2 years after last activity
__utmt
Used to monitor number of Google Analytics server requests
10 minutes
__utmb
Used to distinguish new sessions and visits. This cookie is set when the GA.js javascript library is loaded and there is no existing __utmb cookie. The cookie is updated every time data is sent to the Google Analytics server.
30 minutes after last activity
__utmc
Used only with old Urchin versions of Google Analytics and not with GA.js. Was used to distinguish between new sessions and visits at the end of a session.
End of session (browser)
__utmz
Contains information about the traffic source or campaign that directed user to the website. The cookie is set when the GA.js javascript is loaded and updated when data is sent to the Google Anaytics server
6 months after last activity
__utmv
Contains custom information set by the web developer via the _setCustomVar method in Google Analytics. This cookie is updated every time new data is sent to the Google Analytics server.
2 years after last activity
__utmx
Used to determine whether a user is included in an A / B or Multivariate test.
18 months
_ga
ID used to identify users
2 years
_gali
Used by Google Analytics to determine which links on a page are being clicked
30 seconds
_ga_
ID used to identify users
2 years
_gid
ID used to identify users for 24 hours after last activity
24 hours
_gat
Used to monitor number of Google Analytics server requests when using Google Tag Manager